Absolutely yes! SmartWater4Home works with all rainwater tanks available on the market.

Yes, there is such a possibility. It is possible to use the controller of the SW4H system together with the Hydraulic Unit after making a simple adaptation of the existing system consisting in supplying tap water to the Hydraulic Unit and running an additional water pipe to the rainwater tank for draining water after rinsing the filters from the Hydraulic Unit.

An average property occupies 600 m², of which 300 m² is green area/garden, and the remaining 300 m² is roof + impervious surface (paving stones) from which rainwater can be collected. The average daily demand of the garden (lawn, flowerbeds) is 10 l of water/ m²/ day for 120 days of the growing season. The total water demand is 10 l x 300 m² x 120 days = 360,000 l of water/year i.e. 360 m³. The average annual precipitation in Poland is about 600 l/ m²/ year which is only 180 m³/ year. Therefore, the precipitation should be supplemented by watering – on average min. 180 m³/year. In the case of watering with tap water, at an average price of 10 PLN/ m³ of tap water (+ municipal sewage disposal costs), this gives costs of almost 2000 PLN per year. These costs can be avoided by using stored rainwater for watering

Rainwater better for plants. Rainwater has a low pH and is “soft.”
Rainwater does not contain chlorine and fluoride, and other elements that are harmful to plants, which are found in mains water. Unlike mains water, rainwater is soft water. Rainwater is also better aerated – it contains more oxygen – than tap water Rainwater has a temperature close to the environment – it is not too cold for plant roots in hot weather.

Aushing function, the filters are cleaned and ready for operation at all times. Only when putting the system away for the winter is it recommended to unscrew the housing, remove residual water and manually clean the filter cartridge. Mesh filter cartridges are not replaced unless they are mechanically damaged, for example, as a result of freezing.

Yes, irrigation with SW4H can be managed using the application on your smartphone or on any device equipped with any web browser

Yes, SW4H measures soil moisture and tracks weather forecasts – so the system does not use water unless necessary. However, due to the limited likelihood of precipitation, selected areas may be excluded from weather control.

No, the use of the system does not involve the requirement to purchase a subscription, only maintenance care after the end of the warranty period.

Yes, we provide service throughout Poland.

It depends on the size of the garden. For a garden with an average size of about 300m2, it takes up to 2 working days to install the SW4H system and program it. You should also take into account the time for the groundwork and installation of the irrigation system itself, the foundation of the rainwater tank along with the rainwater supply system, the overflow system and the water supply to the hydraulic unit of the SW4H system.

SmartWater4Home is an irrigation system dedicated to using water from rainwater tanks. The system is a comprehensive solution that works in a fully automated manner, easy to program and manage, with minimal need for manual operation. The system uses rainwater from the tank economically. Rainwater, however, contains mechanical and biological impurities, so it must be filtered. In the event of a shortage of water in the tank, the system replenishes the water using tap water. In doing so, it performs flushing of the rainwater filter.

The system allows you to configure watering zones (depending, for example, on the shading of a particular spot or the individual needs of the plants). Smart Water measures soil moisture and tracks weather forecasts. As a result, the system optimizes water consumption, using less water than with manual watering. With manual watering, we have no control over soil moisture, no control over the amount of water used. The automatic system is more precise and, most importantly, saves time wasted on watering. Of course, the use of an automatic system does not exclude manual watering of separate areas, which in this case can be excluded from the SW4H system by simply deactivating the loop watering the area in question

A low level of rainwater in the tank – below the set minimum will interrupt watering. However, in this case, automatic replenishment of water in the tank with the set amount of tap water will work. At the same time, automatic flushing of the water filter is performed. The replenishment of water in the tank will enable the execution of the next watering cycle. This situation will be repeated until rainfall does not fill the tank above the minimum level

Any irrigation system, including SW4H must be prepared for winter. The system should be emptied of water, for example [by blowing with compressed air] and disconnected from the power supply.These actions should be performed before the onset of sub-zero temperatures. Freezing water can permanently damage system components – such as solenoid valves.

We work with installers and service technicians throughout the country. Please indicate your location and we will recommend one of our business partners.

No, SmartWater4Home is an irrigation system dedicated to using water from a rainwater tank. Instead, the water from the well is ideal for replenishing the water in the tank with an additional pump.

The controller itself is installed with simple assembly tools – wrenches and screwdrivers, pliers for stripping insulation. However, to make the entire irrigation system : piping, valve boxes, watering nozzles, you will need a shovel or rent a mini excavator. These elements are simply buried in the ground – at a depth of 20 – 30 cm. The foundation of a rainwater tank with a capacity of at least 2 m six requires the use of an excavator and even a concrete mixer to fill the tank with sand and cement.

Smart Water 4 Home works with all commercially available rainwater tanks – concrete and plastic.

The filter is an accessory for the hydraulic unit, there is no need to buy it separately.

ABINFORTECH Sp. z o.o.

realizuje projekt dofinansowany z Funduszy Europejskich

pn.: SMARTWATER4HOME – inteligentny autonomiczny system zarządzania zasobami wód opadowych z funkcją integracji z systemami inteligentnych domów SmartHome

Celem projektu jest opracowanie i wprowadzenie na rynek krajowy i zagraniczny innowacji produktowej – inteligentnego sterownika systemu SmartWater4Home do nawadniania ogrodu zgromadzoną wodą opadową.

Planowane efekty: wdrożenie na rynek konsumencki innowacji produktowej – inteligentnego sterownika systemu SmartWater4Home do nawadniania ogrodu zgromadzoną wodą opadową.

Wartość projektu: 1 308 823,00 zł

Dofinansowanie projektu z UE: 957 350,00 PLN.

Pozostałe informacje na: www.mapadotacji.gov.pl

Skip to content